Distributors for the complete range of Cleresolutions products

Case Studies

Case Study - Deckclere

'...A one step solution to algae and mould problems on boat decking & furniture...'

Tandy Too, Emsworth

After a single application of Deckclere all of the algae has been removed even from areas that would be difficult to clean by hand, such as around the toe rails, ventilator cowlings and even from the mooring warps.

'...it took longer to get the hose out than it did to treat the whole boat…'

AB West Sussex

  • Single application - removes algae and prevents regrowth for up to 6-12 months.
  • Easy to apply - spray on using a standard hosepipe.
  • Large coverage - 1L dilutes to 40L with the special applicator provided, giving up to 150m2 of coverage - enough for 2-3 applications on a boat of this size.
  • Biodegradable & environmentally friendly - no special precautions need to be made; can be applied to any exterior surface with the boat in situ.


1 Litre Concentrate w/ applicator (auto-dilutes at 40:1)
5 Litre refill

Typical coverage 150m2
Typical coverage 750m2

How to Apply...

  • Remove any loose debris from the area being treated, allowing the product to treat the surface directly.
  • Apply to dry surfaces to avoid the product becoming over-diluted.
  • Thoroughly wet the surface to be treated with Marineclere Pro using the applicator.
  • Allow to dry fully.
  • As the Marine Range is deliberately non-aggressive, full results may not be seen for up to five to seven days.
  • Areas suffering from particularly heavy growth of algae or mould may require a second application.

Why use the Cleresolutions Marine Range?

  • Completely bio-degradable – the Marine Range is a water-based protection system.
  • Easy to apply - no scrubbing, no brushing and reaches all those awkward areas with no extra effort.
  • Controls 99.99% of all algae, bacteria, moulds, fungi and prevents their reappearance.
  • Environmentally friendly - does not affect marine life in its dilute form.
  • Non-aggressive – does not contain bleaching agents or acids that damage the surface being treated.
  • Removes algae and mould. As part of a seasonal maintenance programme, provides long-term protection against growth of algae and mould - a one step solution to algae and mould problem for marinas.

How to use the hose end applicators - just plug in and spray

Cleresolutions products can be easily applied with our hose end applicator which attaches to any domestic or garden hose pipe using a standard HoselockTM connector or equivalent.

The applicator automatically dilutes the product as its applied.

As easy as watering your garden, just plug the applicator connector (A) into the connector oyour hosepipe and then turn the tap on. Turn the water feed tap (B) through 90 degrees to switch the water on and then turn product feed tap (C) through 90 degrees to start apply the product.

Wash the surface to be treated with a generous coating of Cleresolutions product making sure that the surface is thoroughly wetted. When you have completed applying the product turn taps B and C off and disconnect from the hosepipe. The surface should be left to dry.